Hydrotac OPTX 20/20 Reusable Bifocal Lenses - +1.50 Diopter (Pack of 2)

Stick-On Instructions for Hydrotac Lenses: A Comprehensive Guide

Carefully wash the lenses of your glasses with an oil-free soap and allow them to dry. Using warm water, place a drop of water inside the lens of your glasses where you are going to apply the Hydrotac lens. Take a Hydrotac lens and place it on the inside of the lens, ensuring the curve of the Hydrotac lens matches the curve of your glasses. Hydrotac lenses can be positioned anywhere on your eyeglass lens and should be in the same position, both horizontally and vertically, on either lens. You can reposition the lenses as long as they are still moist. Repeat this process with the second lens.

Using a lint-free cloth, gently press the Hydrotac lenses to force out any excess water. Wear your glasses and make sure your long-distance sight is not obstructed by the Hydrotac lens. If your line of vision is obstructed, remove the lenses using your fingernail and reposition them as instructed. If you require the Hydrotac lenses to be smaller, use a sharp scissors to trim the lenses from the lower-curved side, then install them as before.

While the lenses are fixed to your glasses, complete molecular adhesion will occur in approximately 24 hours. You can always remove Hydrotac lenses using your fingernail to lift the edge. These lenses do not leave any residue behind and can be removed and reused as often as needed.

Please Read Carefully Before Use: Hydrotac lenses are created with the same magnification used to correct simple farsightedness and for reading. They can be mounted to various types of eyewear, but are not intended for driving a car or motor vehicle. Keep Hydrotac lenses out of the reach of young children.

Hydrotac lenses are meant only for seeing things in close proximity or for reading, and are not designed for long-distance viewing. There is a front and back to the Hydrotac lens, with the front curving outward. This is the side that should be adhered to your glasses. Ready-to-wear non-prescription glasses are not intended to replace prescribed corrective lenses or examinations by an eye care professional. Continuous eye check-ups are necessary to determine your eye health status and vision needs.

Frequently Asked Questions & Answers: The recommended method is to use lukewarm tap water generously on the eyewear lenses and the stick-on lenses, then press the stick-on lens firmly in the center and use a cloth to push out any air bubbles. The lenses can be cleaned by peeling them off and using water and oil-free soap. They are reusable, and it's best to apply them to the inside of the eyewear lens. If they don't stay in place, use more water and press firmly. Coatings on the eyewear lens can make application more difficult, but heating them up is not recommended.

product information: